cancel
Showing results for 
Search instead for 
Did you mean: 

USB Low-Full-High Speed Peripherals

New Contributor II

Hello,

    How to change the exposure in FX2LP by using SET command from GUI? (is this only when AEC disable)? what all registers i must change?

Thanks&Regards

Bhavya

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello Bhavya,

You can use Vendor command class for the application and send separate commands to the image sensor for changing the exposure settings. Please refer to the KBA- https://www.cypress.com/comment/264656

Best Regards,

Sananya

View solution in original post

0 Likes
Reply
3 Replies
Moderator
Moderator

Hello Bhavya,

Please refer to the previous thread on the same query-https://community.cypress.com/message/193275?et=watches.email.thread#193275

The registers will depend on your connected image sensor, please let us know which one you are using.

Best Regards,

Sananya

0 Likes
Reply
New Contributor II

Hello sananya

The previous thread is for FX3, and Im doing for fx2lp. is there any other method without using UVC(),

please let me know. and Im using WVGA image sensor.

Thanks&regard

Bhavya

0 Likes
Reply
Moderator
Moderator

Hello Bhavya,

You can use Vendor command class for the application and send separate commands to the image sensor for changing the exposure settings. Please refer to the KBA- https://www.cypress.com/comment/264656

Best Regards,

Sananya

View solution in original post

0 Likes
Reply