Anonymous
Not applicable
Jul 01, 2013
01:27 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 01, 2013
01:27 AM
I've two boards with same circuit based on CY7C68014A. Though one of the boards is working fine, other board is not working correctly and windows reports code 43 error during driver installation.
I noticed that non-working board has +3.3V on D+ line. While I'm able to debug the board through serial port, USB connection is not working. Please advise.
Labels
1 Reply
Jul 03, 2013
12:36 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 03, 2013
12:36 AM
Please check the USB connector soldered on the board. Improper soldering might cause an issue