cancel
Showing results for 
Search instead for 
Did you mean: 

USB Hosts Hubs Transceivers

MaSo_2292026
New Contributor

Respected All,

   

I am working on Project based on CY8CMBR3102 capsense application , to configure this device I want to connect EZclick 2.0 software to device over I2C protocol. I have purchased UMFT201XA USB to I2C converter from FTDI .please guide me how to proceed for configuring device.

   

 

   

Regards

0 Likes
Reply
1 Solution
Anonymous
Not applicable

Hello,

   

 

   

Please refer to the MBR3 capsense design guide document. In the section 5.2 Configuring CY8CMBR3xxx  you will find the details about different ways of configuring MBR3 device.

   

http://www.cypress.com/file/46366/download

   

 

   

Thanks,

   

Ranjith

View solution in original post

0 Likes
Reply
2 Replies
Anonymous
Not applicable

Hello,

   

 

   

Please refer to the MBR3 capsense design guide document. In the section 5.2 Configuring CY8CMBR3xxx  you will find the details about different ways of configuring MBR3 device.

   

http://www.cypress.com/file/46366/download

   

 

   

Thanks,

   

Ranjith

View solution in original post

0 Likes
Reply
MaSo_2292026
New Contributor

Thank you for your reply,but I want to know how to interface UMFT201XA USB  with EZ CLICK2.0

0 Likes
Reply