cancel
Showing results for 
Search instead for 
Did you mean: 

USB Hosts Hubs Transceivers

chetang91
New Contributor

i m using 3-cyusb3324 for a USB hub system.hub-1 is connected to host. Upstream of hub-2 is connected to downstream of hub-1, upstream of hub-3 is connected to the downstream of hub-2. is this possible for me to configure all of three hubs at one go by blaster plus tool by putting all hubs setting (device manger setting) to the vendor driver mode?

0 Likes
1 Solution
Sananya_14
Moderator
Moderator

Hello,

No,  Blaster Plus tool doesnt support batch programming so you would have to configure each EEPROM separately with the hub in vendor mode if you have a separate EEPROM connected to each hub.

Best Regards,
Sananya

View solution in original post

0 Likes
1 Reply
Sananya_14
Moderator
Moderator

Hello,

No,  Blaster Plus tool doesnt support batch programming so you would have to configure each EEPROM separately with the hub in vendor mode if you have a separate EEPROM connected to each hub.

Best Regards,
Sananya

View solution in original post

0 Likes