- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i m using 3-cyusb3324 for a USB hub system.hub-1 is connected to host. Upstream of hub-2 is connected to downstream of hub-1, upstream of hub-3 is connected to the downstream of hub-2. is this possible for me to configure all of three hubs at one go by blaster plus tool by putting all hubs setting (device manger setting) to the vendor driver mode?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
No, Blaster Plus tool doesnt support batch programming so you would have to configure each EEPROM separately with the hub in vendor mode if you have a separate EEPROM connected to each hub.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
No, Blaster Plus tool doesnt support batch programming so you would have to configure each EEPROM separately with the hub in vendor mode if you have a separate EEPROM connected to each hub.
Best Regards,
Sananya