Mar 15, 2021
12:52 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 15, 2021
12:52 AM
I am using CYUSB3324 for a USB HUB System. I want to connect some pin (pin number-85,64,43 ) for pin strapping but i don't know what is the actual significance of these pins for pin-strapping (VID[2:0])? how can i put these pins to pull up or pull down for a default configuration, i can't figure it out ?
Solved! Go to Solution.
Labels
- Labels:
-
USB Hosts Hubs Transceivers
1 Solution
Mar 15, 2021
01:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 15, 2021
01:31 AM
Hello,
Please refer to Table 6 in the datasheet for configuration of the VID[2:0] pins. For default Cypress VID with pin-strapping, these should be pulled up.
Best Regards,
Sananya
1 Reply
Mar 15, 2021
01:31 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 15, 2021
01:31 AM
Hello,
Please refer to Table 6 in the datasheet for configuration of the VID[2:0] pins. For default Cypress VID with pin-strapping, these should be pulled up.
Best Regards,
Sananya