cancel
Showing results for 
Search instead for 
Did you mean: 

USB Hosts Hubs Transceivers

New Contributor

Hi,

If the OVR function is not going to be used in CY7C65634, what should these pins be connected in the schematic?

Should they be connected to ground or simply leave them to be open and unconnected?

Jay

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello,

The OVR# pins are active LOW. So, it is recommended to pull these pins to a logic HIGH through a resistor if they are not used in the design.

Best regards,

Srinath S

View solution in original post

0 Likes
Reply
1 Reply
Moderator
Moderator

Hello,

The OVR# pins are active LOW. So, it is recommended to pull these pins to a logic HIGH through a resistor if they are not used in the design.

Best regards,

Srinath S

View solution in original post

0 Likes
Reply