USB Hosts Hubs Transceivers
- Home
- Products
- USB
- USB Hosts Hubs Transceivers
- Getting up and running with Cypress Suite USB 3.4....
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Mute
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
Hello All
I am trying to configure and run some code on a CY7C67300 EZ-OTG fitted on a Xilinx ML605 board.
I downloaded the Cypress Suite USB 3.4.7 and after reading the instructions got the unsigned driver working on Windows 7 x64 (the device is installed in the device manager).
I have installed the Visual studio C++/C# suites from Microsoft for testing with the examples, however I run into trouble when I am trying to download the firmware code to the processor because the EZ-OTG will not download the code to RAM or EEPROM, it fails saying that "Vendor request failed" and that "A device attached to the system is not functioning"
I am trying to load the firmware via "Download" button in the EZ-USB Interface, is this wrong?
Regards
Kalle
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
SuiteUSB is not the right tool chain. Please look at http://www.cypress.com/?rID=14316