cancel
Showing results for 
Search instead for 
Did you mean: 

USB Hosts Hubs Transceivers

MiRo_263836
Contributor II

Don't want to reset the entire hub with the reset pin , just reset or disconnect/reconnect individual downstream USB ports within the HX3 USB hub device.

Thanks,

Mike

0 Likes
1 Solution
YiZ_31
Moderator
Moderator

Hi,

The ideal way to realize this is to set the soft reset in your device. The host send the vendor command and your device wil reset after receive the command. There are no way the reset the hub downstream port.


Regards.
Eddie

View solution in original post

4 Replies
YiZ_31
Moderator
Moderator

Hi Mike,

No, HX3 is a fixed firmware part. We do not support custom pin usage as described in your requirement.


Regards,
Eddie

0 Likes
MiRo_263836
Contributor II

Is there any firmware way from the Host side to disconnect and reconnect?

0 Likes
MiRo_263836
Contributor II

If there’s a way to do this via software from the upstream device, that would be ideal. I know the upstream device can be used to change the configuration settings stored in EEPROM, and we’re already planning to figure out how to do that from our in-system motherboards. It would be great if there’s some related way to reset individual downstream ports.

0 Likes
YiZ_31
Moderator
Moderator

Hi,

The ideal way to realize this is to set the soft reset in your device. The host send the vendor command and your device wil reset after receive the command. There are no way the reset the hub downstream port.


Regards.
Eddie

View solution in original post