cy4531 connect power adapter error

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
rttt_3611331
Level 3
Level 3
First like given

I try to connect power adapter by cy4531. and cypd3125 flashed the firmware I compiled from cypd3125 notebook sdk.

And I got the below error.

Starting Device Discovery.

0 HID devices found.

1 USB-Serial Bridge devices found.

Error: USB device (0,0) de-initialization failed

0 HID devices found.

1 USB-Serial Bridge devices found.

Flashing device is UFP, initiating DR_SWAP

DR Swap Successful

PD contract established.

Device Discovery completed.

Starting Device Discovery.

0 HID devices found.

1 USB-Serial Bridge devices found.

PD contract established.

Device Discovery completed.

PD contract established.

Restarting the target device

Re-negotiating PD contract after switching target reset

Error: PD contract not established after RESET

Error: DLL call returned error while fetching info

pastedImage_2.png

0 Likes
1 Solution
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

CYPD4531 and EZ-PD Configuration Utility do not support the way your want to flash your device.

Regards,
Eddie

View solution in original post

0 Likes
6 Replies
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

CYPD4531 has only one CCG3 without other chips like CYPD4532. I don't know how did you get the UFP-AMA in your EZ-PD Configuration Utility but Notebook in the target list should be CCG3.

pastedImage_0.png

Regards,
Eddie

0 Likes

Hello,

     UFP-AMA is my power adapter ready to develop,  and connect cy4531 by typec port. And I want to flash my power adapter by cy4531 and ez-pd configuration.

h

0 Likes
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

CYPD4531 and EZ-PD Configuration Utility do not support the way your want to flash your device.

Regards,
Eddie

0 Likes

But it's the way for power adapter developing by cc line.

pastedImage_1.png

0 Likes
YiZ_31
Moderator
Moderator
Moderator
1000 replies posted 750 replies posted 500 replies posted

Hi,

What is the cc controller of your power adapter?

If it's CCG3PA then you could use the mother board of CYPD4532 to update it firmware.

Regards,
Eddie

0 Likes

Hello,

     My power adapter used cypd3175 as the pd control chip,

thx.

H

0 Likes