- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello i have this whole question:
i downloaded the power bank reference design PB-811 and i removed the USB-A i have kept the micro usb for charging and usb- for dual role.
here i have the project found in PSOC CREATOR the CYPD3171-24LQXL-pb.cydsn.
1)i would like to have USB-C dual role to sink and source.
2)i would like it to support BC v1.2, Apple Charging, Qualcomm Charging 4.0, Samsung AFC.
what do i need to change in the code?
my schematic is below
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
1. You need clear the example project CYPD3171-24LQXL-pb.cydsn and refer the Blog link: CY4532 Power Bank Firmware Clear For Single Type-C DRP Design
And then below steps is for your reference.
2. Take a look the pin assignment of CCG3PA on your schematic and confirm the functions of each pin.
3. Add GPIO or I2C master or others as per #2 above.
4. Write C code for those pin defines for #3 above.
5. And re-build and debug firmware and hardware.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
1. You need clear the example project CYPD3171-24LQXL-pb.cydsn and refer the Blog link: CY4532 Power Bank Firmware Clear For Single Type-C DRP Design
And then below steps is for your reference.
2. Take a look the pin assignment of CCG3PA on your schematic and confirm the functions of each pin.
3. Add GPIO or I2C master or others as per #2 above.
4. Write C code for those pin defines for #3 above.
5. And re-build and debug firmware and hardware.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i just checked CY4532 Power Bank, the design is very different from mine i have only ccg3pa CYPD3171 and south-chip SC8913 buck/boost in my design no USB-A.
and it's connected through I2C as below. left is ccg3pa pins and right is SC8913 pins
10 -->> 14 (INT)
12 -->> 13 (SDA)
13 -->> 12 (SCL)
and
14 >> cc2
15 >> cc1
16 >>DM0
17 >>DP0
19 >> CSP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
So that, you can use the project I have been cleaned in the Blog link: CY4532 Power Bank Firmware Clear For Single Type-C DRP Design And then add concerned pins for your project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
what is different in the CYPD3171-24LQXQ_PB exemple code in the Psoc creator and the one you used here? CY4532 Power Bank Firmware Clear For Single Type-C DRP Design
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As referred to Figure 10 in the EZ-PD CCG3PA datasheet. If with 1S battery can we achieve 45W. What voltage and current characteristic for achieve 45W with 1S battery.