USB EZ-PD™ Type-C Forum Discussions
Hello There,
Hope you Doing Fine.
I Have some Question Regarding CYUSB3610.
1. How Many Type-C Wires Required?
2. How Much Power it Can deliver and Distance.
3. Speed and Distance.
4. How many Ethernet Wires Required?
Plz Help
Please provide us the VIF file for Dock SDK.
EZ-PD™ CCGx Dock Software Development Kit (SDK) (cypress.com)
Show Less
Used board : CY4532 EZ-PD
Used program : EZ-PD Configuration Utility
Output spec : PD 20V, PPS 3A or more
Symptom :
1. After setting the output PD 20V / 3.25A, when checking the output, PD 20V / 3A is applied.
2. After setting the output PPS 3.3V~11V / 4.05A, when checking the output, PPS 3.3V~11V / 3A is applied.
How can I use an output of 3A or higher?
Show LessAbout Microsoft modern standby,
https://docs.microsoft.com/en-us/windows-hardware/design/device-experiences/modern-standby
Does Cypress Type-C host design relate this function?
Does need CCG firmware to implement or SDK already supported?
Thanks,
Mitchell
Show LessHi,
I have a debug accessory I have created that pulls both CC1 and CC2 to ground through 5.1k resistors.
This is correctly recognized as a debug accessory by the PD controller and I can configure the mux to my specifications to send debug signals out. However I would also like to supply 5V on VBUS (enable psrc) to the debug accessory so it can be powered from the host at the same time. Looking through the source to the project I am not sure how to do this, as I think this is done by the DPM.
Is this possible?
Thanks for your help
Show LessHello Cypress-Team,
we are using the CYPD3125-40LQXIT on a custom board. I could connect to the board with the PSoC Programmer to read the memory from the device, so the connection should be ok and the device is working. I want to load some new PDOs with using EZ-PD configuration utility, as I have done with the CY4521 CCG2 EVK, but I'm not sure how I could do this. We did not design the CY7C65215 on the board to have an USB/I2C converter. As a test, I took the following pins from the daughter card of the CY4521 and connect it to our custom board, without any success. It only finds the CCG2 device on the dev kit
J4.37: I2C_SCL_EC
J4.34: I2C_SDA_EC
J4.28: I2C_INT_EC
Which possibilities I have to configure the CYPD3125-40LQXIT on our custom board via EZ-PD configuration utility?
BR Holger
Show LessIs the CCG2 60W Car Charger Reference Design completely standalone, with the provided firmware?
I have no host controller and otherwise need to know if I need to make any firmware changes. The specs of the board are fine as-is for my application.
Show LessHi, Sir,
Customer platform is Alder Lake ( ADL ) using CCG5, not CCG6DF.
Can i use Host SDK Version 3.4's CYPD5225-96BZXI_notebook_tbt project to implement ADL platform?
Do I need to make any changes on CYPD5225-96BZXI_notebook_tbt 's FW to implement ADL ?
Show Less
Hi, I use CY4532-EVK as a power adapter, I supply power to j2, connect it to macbook via typeC, and 20V pulses start, after a while it stabilizes and starts charging. Why are there 20V pulses at the beginning at the output?
Show Less