USB EZ-PD™ Type-C Forum Discussions
Please provide me the CYPD3172P - Chip Programming Guide
Hello!
I can speak a little English. Sorry!
I make a b/d to this site : https://www.cypress.com/documentation/reference-designs/ez-pd-ccg3-usb-type-c-charge-through-dongle
And HEX FILE receive to Cypress FAE.
This B/D Power OUT : 15V (Min : 13.05V, Max : 15.75V, Current 2.32A)
I want change Voltage and Current : 20V 3A
Can I receive change Hex File and Project File ?? Plz!!
This is EZ-PD Analyzer Utility Capture.
Thank you for reading it.
Show Less
I am looking to design a USB to PS/2 converter for BOTH a mouse and keyboard interface. What type of chips and reference design do you offer ?
Please provide us the HX3PD's thermal values ( Ta , Tj , Tja , Tjc , Rja , Rjc )
I am interested in the CYPD72xx / CCG7D listed on the product training sheet.
However, the data sheet has not been published on the web yet.
Can I show you the datasheet?
Show Less
We are targeting to build a rear seat charger using CCG3PA - CYPD3175-24LQXQ .
i) We would like to control the external supply (DCDC) - TLE5542-1QV using digital control (SPI) instead of via analog FB pin.
Can you provide an example code which support digitally controlled power supply via SPI ?
ii) As currently we have an eval kit CY4532 - with power board using CYPD3171-24LQXQ. What is the difference between CYPD3171-24LQXQ vs CYPD3175-24LQXQ. can we use the SDK to test and build code for CYPD3175-24LQXQ rear charger using the CY4532 kit ?
Show Less
Does Cypress have type-c e-mark chip to support PD3.1 spec to support 240W power?
if have, Please provide us e-mark configuration file or FW hex.
Show Less
We have develop a board with a chip CYPD4126-40LQXI. When I connect the USB-C port to another product, sometimes a hard reset is sent. So, the other product reboot. How I could know why your stack PD sent a hard reset message?
Show LessWe have an issue in one of our designs where the CYPD3125 is not communicating with any host device. We had it working at one point with the power negotiation functioning as expected with CY4531 evaluation kit. After one good power up the CY4531 evaluation kit no longer functioned as expected. It will not power up our device or other off the shelf USBC products we verified work with other supplies. Even the USB flash demo will no longer work on the CY4531. Since then we have tried using a separate USBC power supply device. We have verified this supply works with other, off the shelf USBC devices. But our board will not power on.
All we see with the packet analyzer when attaching our board is the source sending out SOURCE_CAP messages. Our board's CCG3 never seems to respond to these. It also will inconsistently draw the current limit of the supply, 3A. Every few packets in the CY4500 analyzer output shows -3A on VBUS and no current otherwise.
We tried reworking the board to replace the CYPD3125 and still see the issue. We also tried plugging the board in while there was no CCG3 device on it and did not see any current draw with the analyzer, so we don't think there is a short on the board itself (unless there is a reason for the analyzer readout to not function with one side of the connection not having a CCG3). The firmware we are using was functional when the power negotiation worked once so we don't think that is a cause of failure. Plus the firmware does work on our other designs.
Any insight or support to help track down the problem would be greatly appreciated.
Show Less