cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

New Contributor II

Hi

Q1) Is it ok to think that CYPD3177 can detect changes in external signals(H/L)?
Q2) Is there a way to put CYPD3177 on standby using GPIO?
Q3) I am thinking that It would be possible to use I2C and put it on standby, but is it actually done using the HPI protocol?
Q4) Also, is it possible to enter both Sleep / DeepSleep as above(Q2 and Q3)?

Best Regards

Arai

0 Likes
Reply
1 Solution
Moderator
Moderator

Unfortunately, CYPD3177 (BCR) default firmware does not enter neither Sleep nor DeepSleep mode.

This dicussion had already closed.

Best regards,

Hirotaka Takayama

View solution in original post

0 Likes
Reply
5 Replies
Moderator
Moderator

Hi ,

A1: It is possible to achieve that.

A2: It is possible, but you need to make sure you do not care other conditions (CC negotiation, ...).

A3: CCG3PA is not support HPI. If you could like to use I2C command to let CCG3PA enter deep sleep mode, it is similar as #2 above which is need firmware customize support.

A4: It is possible to achieve that.

Best Regards,

Lisa

0 Likes
Reply
New Contributor II

Hello Lisa san

This is BCR device(CYPD3177), Connect the external microcomputer and BCR(CYPD3177) with GPIO.

Q1)

If they want BCR(CYPD3177) to be on standby or wake-up from standby by an edge signal(H->L, L->H) from the microcomputer, could you  please tell me the details for setting of BCR(CYPD3177)?


Q2)

Also, I would like to turn Vbus FET off when BCR(CYPD3177) is on standby. Is it possible turned off automatically?

If impossible, pleasse tell me how to control Vbus FET Synchronize to the state of standby

Best Regards

Arai

0 Likes
Reply
New Contributor II

Hi

Any updates? We have to make clear about BCR stanby function ASAP.

Bets Regards

Macnica/Arai

0 Likes
Reply
New Contributor II

Hi

This is additional questiones.

There are descriptions of Sleep and Deep sleep mode in the BCR Data Sheet, but how can I put it into sleep mode? and, how can I wake-up from each sleep modes?

(In English)

BCRのデータシートには、SLEEPとDEEP SLEEPという記述がありますが、どのようにして、これらのスリープモードに入れる事が出来るのでしょうか?又、ウェイクアップの方法も教えて下さい

荒井

0 Likes
Reply
Moderator
Moderator

Unfortunately, CYPD3177 (BCR) default firmware does not enter neither Sleep nor DeepSleep mode.

This dicussion had already closed.

Best regards,

Hirotaka Takayama

View solution in original post

0 Likes
Reply