- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Q1) I think ACG1F includes the boot loader FW at the time of shipment. Is this correct?
Also, is it an I2C boot loader?
Q2) I think that an application (SDK) is required to operate ACG1F other than the above boot loader, but where should I get the SDK?
Q3) I think that it is possible to program FW via SWD with Miniprog3. Is this correct?
Q4) Is there a reference schematic or reference board other than the data sheet?
Solved! Go to Solution.
- Labels:
-
USB EZ-PD Type-C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Arai,
Kindly refer my comments as below:
Q1) I think ACG1F includes the boot loader FW at the time of shipment. Is this correct?
Also, is it an I2C boot loader?
>> You are correct, it is I2C boot loader.
Q2) I think that an application (SDK) is required to operate ACG1F other than the above boot loader, but where should I get the SDK?
>> Currently, ACG1F is not supported in latest SDK. The firmware of ACG1F is responsible by IFX local Application Engineer.
Q3) I think that it is possible to program FW via SWD with Miniprog3. Is this correct?
>> Yes, it is.
Q4) Is there a reference schematic or reference board other than the data sheet?
>> We have Intel reference design based on ACG1F. You could get those schematic from Intel. We also have .dsn or .pdf of ACG1F evaluate board could be shared if you are going to contact IFX technical Support Center.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Arai,
Kindly refer my comments as below:
Q1) I think ACG1F includes the boot loader FW at the time of shipment. Is this correct?
Also, is it an I2C boot loader?
>> You are correct, it is I2C boot loader.
Q2) I think that an application (SDK) is required to operate ACG1F other than the above boot loader, but where should I get the SDK?
>> Currently, ACG1F is not supported in latest SDK. The firmware of ACG1F is responsible by IFX local Application Engineer.
Q3) I think that it is possible to program FW via SWD with Miniprog3. Is this correct?
>> Yes, it is.
Q4) Is there a reference schematic or reference board other than the data sheet?
>> We have Intel reference design based on ACG1F. You could get those schematic from Intel. We also have .dsn or .pdf of ACG1F evaluate board could be shared if you are going to contact IFX technical Support Center.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Lisa san
Thank you for your reply.
I will close this question.
Best Regards
Arai