Apr 22, 2021
12:13 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Apr 22, 2021
12:13 PM
Hi Cypress community,
We have a host CCG3PA PD controller (DFP) connected to a second (UFP) PD controller via a USB-C cable with an embedded EMCA chip (CMG1). Normally, when the CCG3PA is plugged into the UFP PD controller with this cable, CCG3PA can read the data from the EMCA (CMG1) chip, as well as communicate with the UFP PD controller over CC wire.
However, if CCG3PA is plugged into the CMG1 EMCA cable only (so no UFP device connected on the other side), is it possible that CCG3PA can read the data from the CMG1 EMCA chip without an UFP present? I tried this setup with the Cypress PD Analyzer, but I didn’t see any CC packet exchanged.
Thanks,
Jonathan
Labels
- Labels:
-
USB EZ-PD Type-C
1 Reply