- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can we use the I2C to control CCG2. Like to check if device present or not or start/stop charging ? If so is there any API documentation for that?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Meran,
Yes, you can. There are some registers can be accessed by I2C. And Cypress owned a documentation which list out related registers and the way you need to communicate with CCG2. The best way to get the documentation is contact your local FAE. If you have not been contacted local Cypress, feel free to select one of them to contact it. Link: Cypress Franchised Distributors | Cypress Semiconductor
Meanwhile, you could get all of API of CCGx firmware from SDK API user guide. LINK: http://www.cypress.com/documentation/software-and-drivers/ez-pd-software-development-kit?source=sear...
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Meran,
Yes, you can. There are some registers can be accessed by I2C. And Cypress owned a documentation which list out related registers and the way you need to communicate with CCG2. The best way to get the documentation is contact your local FAE. If you have not been contacted local Cypress, feel free to select one of them to contact it. Link: Cypress Franchised Distributors | Cypress Semiconductor
Meanwhile, you could get all of API of CCGx firmware from SDK API user guide. LINK: http://www.cypress.com/documentation/software-and-drivers/ez-pd-software-development-kit?source=sear...
Best Regards,
Lisa