- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used CYPD3174-24LQXQ on the adapter and the adapter is making 3.8V , the chipset has the firmware and configuration for USB-PD (5,9,12,15,20v) and with the external regulator, it works but with this chipset it makes only 3.8V (not 5V). any idea?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Lisa, thanks for the response.
the Adapter (DC/DC)works with external resistor network and voltage divider change to make 5v up to 20V; but when I disconnected the TLV analogue regulator and connected OPTO and FB to Cypress chipset it made only 3.8V.
R50 is the analogue voltage divider`s upper resistor (removing that resistor didn't help)
when I put R34 = 47ohm it started working! any idea?
you can reach me on my Infineon email for further discussion.
Thanks
Robert
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
Could you please kindly confirm the AC/DC or DC/DC output can be output 5.0V with Vfb=1.2V? Or Could you please kindly confirm the AC/DC or DC/DC output can be output 5.0V with external resistors original?
It will be helpful if you could attach your schematic.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Lisa, thanks for the response.
the Adapter (DC/DC)works with external resistor network and voltage divider change to make 5v up to 20V; but when I disconnected the TLV analogue regulator and connected OPTO and FB to Cypress chipset it made only 3.8V.
R50 is the analogue voltage divider`s upper resistor (removing that resistor didn't help)
when I put R34 = 47ohm it started working! any idea?
you can reach me on my Infineon email for further discussion.
Thanks
Robert
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Robert,
R34 is mandatory load on for feedback secondary side. From CCG3PA side, the opto feedback structure is below:
Kindly let me know if you have any concerns.
Best Regards,
Lisa