- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I've a ccg3pa DVK kit
Would you please let me know how to use MiniProg4 as debugger, set breakpoints, run or stop on the PSoC Creator.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the following KBA https://community.cypress.com/docs/DOC-17692 for debugging Miniprog 4 as a debugger.
Also make sure the main board has jumper J6 set to short pins 2 and 3 (VDDD-VTARG)
Best Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the following KBA https://community.cypress.com/docs/DOC-17692 for debugging Miniprog 4 as a debugger.
Also make sure the main board has jumper J6 set to short pins 2 and 3 (VDDD-VTARG)
Best Regards,
Mallika
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry for a mistake in the first line,
Refer to the KBA https://community.cypress.com/docs/DOC-17692 for debugging CCG3PA with a Miniprog 4.
Regards,
Mallika