cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

HsCh_3227321
New Contributor

Hi

I need to configure the ccg2 on the development board as the eMarker to simulate the cable.

Can i use the miniProg3 to configure the ccg2?

Thanks.

John

0 Likes
1 Solution
ShifangZ_26
Moderator
Moderator

Hi John,

The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.

If you want to update firmware image totally, you need MiniProg3.

Best Regards,

Lisa

View solution in original post

0 Likes
2 Replies
ShifangZ_26
Moderator
Moderator

Hi John,

The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.

If you want to update firmware image totally, you need MiniProg3.

Best Regards,

Lisa

View solution in original post

0 Likes
HsCh_3227321
New Contributor

Hi lisa

How to update configure table of CCG2?

If I want to change the VDO setting, I  just update the configure table?

Thanks.

John

0 Likes