How to configure the CY4502 EZ-PD™ CCG2 Development Kit

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
HsCh_3227321
Level 1
Level 1

Hi

I need to configure the ccg2 on the development board as the eMarker to simulate the cable.

Can i use the miniProg3 to configure the ccg2?

Thanks.

John

0 Likes
1 Solution
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi John,

The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.

If you want to update firmware image totally, you need MiniProg3.

Best Regards,

Lisa

View solution in original post

0 Likes
2 Replies
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi John,

The CY4502 is the EMCA evaluate board. You just need update the configure table of CCG2 is enough to simulate the cable. Actually, the chip have pre-programmed firmware inside. If you just want to simulate EMCA cable, just use it.

If you want to update firmware image totally, you need MiniProg3.

Best Regards,

Lisa

0 Likes

Hi lisa

How to update configure table of CCG2?

If I want to change the VDO setting, I  just update the configure table?

Thanks.

John

0 Likes