HDMI source over USB-C

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Anonymous
Not applicable

Hello,

regarding: Block diagram: New HDMI Source

http://www.cypress.com/applications/consumer-electronics/native-hdmi-over-type-c-alternate-mode

Where I can find suitable application note?

We have source Device with USB3.0 signals, and HDMI output (this is DC-coupled in opposite to DP) and some DDC(SDA,SCL), CEC outputs

So we have to send the above signals DDC&CEC over CC1/CC2 channel, detect HPD from CC1 and SBU1. We do not need HEAC.

Note, 900mA sourcing is enough.

Proper MUX and USB-PD controller needed.

Can you advice here?

Per TI note (http://www.ti.com/lit/an/slla333/slla333.pdf ) there is difference in HDMI output connection to muxes, and few other points to consider.

Regards,

Grzegorz .

0 Likes
1 Solution
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi Grzegorz,

It is better way to contact local Cypress FAE or Rep with your request and then get the reference schematic for your design directly. Cypress have such design for USB3.0 host, HDMI source solution.

There are no application notes available for this solution so far.

Best Regards,

Lisa

View solution in original post

0 Likes
1 Reply
ShifangZ_26
Moderator
Moderator
Moderator
10 likes given 250 sign-ins 1000 replies posted

Hi Grzegorz,

It is better way to contact local Cypress FAE or Rep with your request and then get the reference schematic for your design directly. Cypress have such design for USB3.0 host, HDMI source solution.

There are no application notes available for this solution so far.

Best Regards,

Lisa

0 Likes