Mar 19, 2019
07:35 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 19, 2019
07:35 PM
Hello
I want to write a HEX(CYPD3171-24LQXQ_pb_3_3_0_1882_0_0_0_pb.hex) file using Miniprog3 on CCG3PA of CY4532. But how do I set board jumper settings and Psoc programmer settings?
Because after push the "Program" of PSoC programmer, programming will not start.However, no error occurs on PSoC Programmer.
Best Regards
Arai
Solved! Go to Solution.
1 Solution
Mar 19, 2019
07:51 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 19, 2019
07:51 PM
Short pin 2 and pin 3 (VTARG and VDDD) on J6 on EVK MAIN BOARD.
Short J5 and J7 on EVK MAIN BOARD.
PSoC Programmer settings is as follows.
Read CY4532 Evaluation Kit Guide for the connection between MiniProg3 CONNECTOR and CCG3PA if needed.
Best regars,
Hirotaka Takayama
2 Replies