cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

NoAr_1540581
New Contributor II

Hello

I want to write a HEX(CYPD3171-24LQXQ_pb_3_3_0_1882_0_0_0_pb.hex)   file using Miniprog3 on CCG3PA of CY4532. But how do I set board jumper settings and Psoc programmer settings?
Because after push the "Program"  of PSoC programmer, programming will not start.However, no error occurs on PSoC Programmer.

Best Regards

Arai

0 Likes
1 Solution
HirotakaT_91
Moderator
Moderator

Short pin 2 and pin 3 (VTARG and VDDD) on J6 on EVK MAIN BOARD.

Short J5 and J7 on EVK MAIN BOARD.

PSoC Programmer settings is as follows.

pastedImage_1.png

Read CY4532 Evaluation Kit Guide for the connection between MiniProg3 CONNECTOR and CCG3PA if needed.

Best regars,

Hirotaka Takayama

View solution in original post

0 Likes
2 Replies
HirotakaT_91
Moderator
Moderator

Short pin 2 and pin 3 (VTARG and VDDD) on J6 on EVK MAIN BOARD.

Short J5 and J7 on EVK MAIN BOARD.

PSoC Programmer settings is as follows.

pastedImage_1.png

Read CY4532 Evaluation Kit Guide for the connection between MiniProg3 CONNECTOR and CCG3PA if needed.

Best regars,

Hirotaka Takayama

View solution in original post

0 Likes
NoAr_1540581
New Contributor II

Hello Takayama san

I understood.

Thank you for your reply.

Best Regards

Arai

0 Likes