cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

Contributor II

Q: where  i could  find  address of  each part  in FLASH Memory

Q : when  i load hex file  i update only fw application or also configuration table  area ?

0 Likes
Reply
1 Solution
Moderator
Moderator

Hello,

The bootloader and configuration table size will be as per what is mentioned in the User Guide i.e. around 4KB and 1KB. The application firmware size may vary as per the project so the address is not mapped in the diagram. So, the bootloader will start at 0x0000 followed by the configuration table at 0x1100.

You can find the flash memory map settings in the linker script cm0gcc.ld and the flash_config.h file.

Best Regards,

Sananya

View solution in original post

0 Likes
Reply
3 Replies
Moderator
Moderator

Hello,

-Please refer to Section 5.4 in the Power SDK User Guide for Flash Memory Map details.

-Updating the .hex file will update both the application firmware and configuration table.

Best Regards,

Sananya

0 Likes
Reply
Contributor II

in section 5.4  there is no address  only visual image

0 Likes
Reply
Moderator
Moderator

Hello,

The bootloader and configuration table size will be as per what is mentioned in the User Guide i.e. around 4KB and 1KB. The application firmware size may vary as per the project so the address is not mapped in the diagram. So, the bootloader will start at 0x0000 followed by the configuration table at 0x1100.

You can find the flash memory map settings in the linker script cm0gcc.ld and the flash_config.h file.

Best Regards,

Sananya

View solution in original post

0 Likes
Reply