- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm trying to program a CCG4 based chip using the EZ-PD Configuration Utility. Which devices are supported as the bridge in this application?
So far I've only been able to use a CY7C65215 chip to work with the "EZ-PD Configuration Utility". I've tried using several versions of a PSoC from a development board setup as a bridge without success, I've also tried using an Aardvark from TotalPhase without success.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
You are correct. This is only support by Cypress USB to Serial chips, CY7C6521x (CY7C65215,CY7C65210,CY7C65211, CY7C65219).
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
You are correct. This is only support by Cypress USB to Serial chips, CY7C6521x (CY7C65215,CY7C65210,CY7C65211, CY7C65219).
Best Regards,
Lisa