Debug( programing and run) Application CCG3PA Car Charger (CLA) with MiniProg3 SWD Interface on CY4532 EZ-PD™ CCG3PA EVK

Announcements

Live Webinar: USB-C adoption. Simple & Cost-efficient solutions | April 18th @9am or 5pm CEST. Register now !

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Geromino
Level 5
Level 5
50 replies posted 25 replies posted 10 replies posted

i want  to verifying  the correct setup jumpers  on the  main and power  board  when  using MiniProg3  debug Car Charger (CLA)

CY4532 EZ-PD™ CCG3PA Evaluation Kit Guide.pdf  acorrding  this document  there is instruction and setup jumpers to programming CY4532 EVK

also  there is instruction and setup jumpers to run Running the Power Adapter Demo  but  the info  which  am looking for  is info  for

Debug( programing and run) Application CCG3PA Car Charger (CLA) with MiniProg3 SWD Interface  on CY4532 EZ-PD™ CCG3PA EVK

what  is the correct setup jumpers  in  main and power board  in order  programming  and  debugging  via PSoC  Creator 4.3  when press

run_debug_CCG3PA Car Charger (CLA).PNG

attached excel  with  table of setup jumpers  

0 Likes
1 Solution
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please use the following jumper settings in debug mode for CLA project-

Power  Board:

J6, J7, J9: NC

J14: 1-2

Main Board:

J2, J3, J4: 1-2

J6: 2-3

J5, J7: NC

Please refer to the KBA for setting the MiniProg3 configuration on PSoC Creator as well.

Best Regards,

Sananya

View solution in original post

0 Likes
1 Reply
Sananya_14
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hello,

Please use the following jumper settings in debug mode for CLA project-

Power  Board:

J6, J7, J9: NC

J14: 1-2

Main Board:

J2, J3, J4: 1-2

J6: 2-3

J5, J7: NC

Please refer to the KBA for setting the MiniProg3 configuration on PSoC Creator as well.

Best Regards,

Sananya

0 Likes