Hello,
>> No, usb micro B cable cannot be used as this implies programming the ccg3pa controller over cc interface. The only workaround now is to program using miniprog kit. (https://www.cypress.com/documentation/development-kitsboards/cy8ckit-002-psoc-miniprog3-program-and-... ). This method of programming is called swd programming.
For SWD programming of CCG3PA the steps are as follows-
1) Remove any external supply to the kit.
2) Remove jumpers on J6 and J7 of the power board.
3) On jumper J6 of main board, short pins 2-3 (VDDD-VTARG).
4) Connect a MiniProg3 Programmer/Debugger (CY8CKIT-002) to the SWD header J1 on the main board and connect the MiniProg3 USB interface to a PC.
>> Regarding 3, yes I meant capturing cc logs using the CY4500 analyzer.
Regards,
Mallika
