cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

falu_294486
New Contributor

Hi,

I design a type c port test card, when i try to pr_swap with mac book, it can not be success.

(dell laptop could be work)

the cc analysis are below

123.JPG

0 Likes
Reply
1 Solution
YatheeshD_36
Moderator
Moderator

Hello,

Please add higher source PDOs on the CCG4 side. For example 9V / 3A and 12V / 3A.

Which SDK version and firmware are you using?

Best Regards,

Yatheesh

View solution in original post

0 Likes
Reply
5 Replies
YatheeshD_36
Moderator
Moderator

Hello,

Can you please confirm if the CCG is initiating the PR_Swap and sending PS_RDY to the PC and are you using an EMCA cable?

And can you please share the logs where the Power role swap was successful(with DELL Laptop).

Best Regards,

Yatheesh

0 Likes
Reply
falu_294486
New Contributor

Hi Yatheesh,

  I didn't use EMCA cable, juest normal typeC cable.

below is dell laptop charge

0 Likes
Reply
YatheeshD_36
Moderator
Moderator

Hello,

Seems like the CCG is not responding with a PS_RDY after acknowledging the PS_RDY sent by the laptop. Please use EMCA cable and try the same.

Please connect the CCG to the laptop without powering the CCG externally and check if there is reset of CCG when it initiates a PR_SWAP.

Best Regards,

Yatheesh

0 Likes
Reply
falu_294486
New Contributor

Hi Yatheesh,

Why I can PR_SWAP success in DELL laptop, but in MacBook, it's not success.

in my design, I have to supply power to PD through external power and do not use EMCA cable.

What caused the problem when CCG reset after PR_SWAP

0 Likes
Reply
YatheeshD_36
Moderator
Moderator

Hello,

Please add higher source PDOs on the CCG4 side. For example 9V / 3A and 12V / 3A.

Which SDK version and firmware are you using?

Best Regards,

Yatheesh

View solution in original post

0 Likes
Reply