- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Cypress,
I have a problem with CYPD3171 evaluation board (CY4532), because it doesn't charge battery connected to it (2S Li-Ion). Firmware which I use: "CYPD3171-24LQXQ_pb_3_3_0_1882_0_0_0_pb.cyacd" (uploaded via EZ-PD Configuration Utility). Device as source works correctly, but when I connect any adapted (via USBC) no current is flowing to battery. I measure some votlages and:
- SC8802_DIR is low while adapter connected (so ok),
- SC8802_EN is low while adapter connected (so ok),
- voltage at TP14 is 5V while adapter connected (so voltage on VBUS_P is present),
- jumpers on main board: J2, J3, J4 - 2-3, J6 - 1-2, J5, J7 not connected,
- jumpers on powerboard: J6, J7, J9 - 1-2,
- battery voltage - 6.8V.
It looks like the SC8802 is not respect the DIR pin, because while adapter connected, current is flowing from battery to eval board.
Am I doing something wrong?
I am looking forward to Your help.
Solved! Go to Solution.
- Labels:
-
ispn:39570:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
In order to get higher voltage, you should have matched PDO for CCG3PA and power adapter. You should know the source PDOs of your power adapter then set the corresponding sink PDO for CCG3PA.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Do you have a sniffer to capture the CC log of Type-C port? It seems the PD contract is not estbalished.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Unfortunately I haven't. I have only some USB dongle testers (power-z).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can anyone help me please?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Already I use USB power dongle with simple sniffer features and I noticed that CYPD3171 not respond to "get sink capabilities" command. I tried with different Sink PDO profiles. It is needed to check another option in EZ-PD Configuration Utility?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
My I see your log? Usually CCG3PA PB FW will respond to Get_Sink_Cap.
Regards,
Eddie
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Eddie,
I fix the problem - hardware one, which was hard to find.
I have another small question - is it possible to set charging voltage higher than 5V (I set different Sink PDO profile and I use adapter with PD output, but MCU doesn't change profile). It is charging only with DCP profile.
Best regards
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
In order to get higher voltage, you should have matched PDO for CCG3PA and power adapter. You should know the source PDOs of your power adapter then set the corresponding sink PDO for CCG3PA.
Regards,
Eddie