- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @LisaZ_26
This thread is regarding CYPD3125 Hardware Configuration. Still am facing same problem can't able to reply for previous thread and can't able to create even discussion.
As per your suggestion, used Miniprog3 for programming via SWD interface and programming also succeed.
But Across VBUS getting milli volts only and even mosfet's are also not enabled, across VBUS_P_CTRL0/1 getting milli volts.
The MOSFET's are N-Type MOSFET. Attached schematics for your reference
Programmed CYPD3125-40LQXI_notebook firmware. Kindly advise to overcome this problem.
Regards
Srini
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Srini,
1. It seems you can reply this threads and the other threads (). Let's tracking the new question in this threads.
2.DMG2305UX is P MOS FET on VBUS_P_CTRL. It is not match CY4531. CY4531 use N MOS FET on the provider path.
https://www.diodes.com/assets/Datasheets/DMG2305UX.pdf
Based on this hardware, you need change the configure of FET type in main.c. Below is original configure for this.
For your case, you can change to
pd_hal_set_fet_drive(PD_FET_DR_P_JN_FET, PD_FET_DR_P_JN_FET);
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Srini,
1. It seems you can reply this threads and the other threads (). Let's tracking the new question in this threads.
2.DMG2305UX is P MOS FET on VBUS_P_CTRL. It is not match CY4531. CY4531 use N MOS FET on the provider path.
https://www.diodes.com/assets/Datasheets/DMG2305UX.pdf
Based on this hardware, you need change the configure of FET type in main.c. Below is original configure for this.
For your case, you can change to
pd_hal_set_fet_drive(PD_FET_DR_P_JN_FET, PD_FET_DR_P_JN_FET);
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Liza,
Thanks for your reply. In hardware itself changed to N channel MOSFET( 2N7002). Still functioning is not happening.
https://www.mouser.in/datasheet/2/308/2N7002-1305074.pdf
Is there any other issue with our customized board. Please kindly help us. Soon we planned for the production based on the result of the prototype.
Regards
Srini
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Srini,
1. The 390pF cap on CC1 and CC2 pins of CYPD3125. Refer C17 and C20 as below.
2. Recommend you remove Q3 and Q4 when you bring up the board. Since the Vgs(th) SPEC is below:
At the beginning, the CC1 and CC2 is toggling with 3.3 and 0V, you can measure it on your board.
Best Regards,
Lisa