cancel
Showing results for 
Search instead for 
Did you mean: 

USB EZ-PD Type-C

kaursugr_485495
New Contributor

Hi Everyone,

I am designing a PCB using CY6611- EZ-USB HX3PD Evaluation Board. I was working on the Schematic of my PCB. I was not able to find the AIC6156 power switch by Analog Integrations Corporation used for non-PD ports (DS2 to DS7). 

Can you please help with the datasheet/ information/alternative of the same.

Thanks

Sugreev

0 Likes
1 Solution
Sananya_14
Moderator
Moderator

Hi Sugreev,

I found the datasheet of AIC6156 here but I couldnt see it available in stock. You could refer to alternative 5V VBUS power switches used in our other reference designs TPS2556DRBTTPS2559DRCR and AP21510.

Best Regards,
Sananya

View solution in original post

0 Likes
3 Replies
Sananya_14
Moderator
Moderator

Hi Sugreev,

I found the datasheet of AIC6156 here but I couldnt see it available in stock. You could refer to alternative 5V VBUS power switches used in our other reference designs TPS2556DRBTTPS2559DRCR and AP21510.

Best Regards,
Sananya

View solution in original post

0 Likes
kaursugr_485495
New Contributor

Hi Sananya,

I couldn't find the alternative 5V VBUS power switches as well. I found one similar one - AP2301A/AP2311A (digikey.com). 

Can I use this one??

I am also not able to find Right Angle 3.1 USB Connector- UAA1111-44118-7H as well. Can you please tell me alternative of this one as well ?

Thanks

Sugreev

0 Likes
Sananya_14
Moderator
Moderator

Hi Sugreev,

Yes, that would work and you could also check AP22615, which would allow you to set the current limit to higher values as per your port charging configuration.

For USB 3.0 connector, you could check the parts UEA1112C-4HK1-4H, UEB1112C-2AK1-4H and 10117835-001LF.

Best Regards,

Sananya

0 Likes