- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
This is the USB4 cable I purchased.
The cable information of this product was conf irmed using CY4500.
The result is displayed in this message USB_3_1_GEN1_GEN2 instead of USB4.
Why is the cable, which is a USB IF certified product, unable to display the USB4 message on the CY4500 protocol analyzer?
Solved! Go to Solution.
- Labels:
-
ispn:39566:1:0
-
l1:314:1:0
-
USBEZ-PDType-C
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please confirm if the following thread was created with respect to this.
https://community.cypress.com/t5/USB-EZ-PD-Type-C/EZ-PD-Protocol-Analyzer-Utility/td-p/266179
Regards,
Abhilash P
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Can you please confirm if the following thread was created with respect to this.
https://community.cypress.com/t5/USB-EZ-PD-Type-C/EZ-PD-Protocol-Analyzer-Utility/td-p/266179
Regards,
Abhilash P