- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello, I have set up the config tool to have BC 1.2 charging and Aple 2.4A support.
When I test the device, the current is limited to less than 1.5A.
The circuit can handle 30W and the system is set up to report 5V/3A. 9V/3A, 15V/1.95A.
We can see Type-C USB devices pulling 3A, so why does the Apple product get limited to less than 1.5A?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Richard,
May I know whether you have see 2.2-2.89V on D+ and D- with Apple Charging 2.4A mode? If yes, this is not CCGx issue.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Richard,
May I know whether you have see 2.2-2.89V on D+ and D- with Apple Charging 2.4A mode? If yes, this is not CCGx issue.
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you not tell another customer that they cannot do this in another thread?
https://community.cypress.com/message/156776?et=watches.email.thread#156776
When is the new SDK that fixes this issue?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Richard,
The Next SDK will fix this issue. The release schedule for next SDK release is unavailable at present
Best Regards,
Lisa