- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to implement the CCG2 Paddle Card Reference Design using the CY4502 and CY4501 development kits. The reference design and files I am using are from here: https://www.cypress.com/documentation/reference-designs/ez-pd-ccg2-electronically-marked-cable-assem...
I followed the directions for Batch Programming of EMCA Cables in the EZ-PD Configuration Utility User Manual (section 3.2.2), but when I try to program the CY4502 board the 'Start' button is always greyed out (screen shot below). I am using v1.2 build 287 of the EZ-PD Config Utility. I programmed the CY4504 Host board with the FlashUtil in the EZ-PD Config Utility Firmware folder.
How can I get the 'Start' button to be active?
Solved! Go to Solution.
- Labels:
-
ispn:39567:1:0
-
l1:314:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Update: I re-flashed the CY4502 with the 1.0.3.898 FW and then things started working. Thanks.