Mar 16, 2020
10:55 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 16, 2020
10:55 AM
Hi, question here.
As far as I understand, the PPS required 50mA current steps.
But in datasheet, the resolution of the current sensing amplifier is specified as 100mA.
Then How do I suppose to achieve PPS using this chip?
Solved! Go to Solution.
1 Solution
Mar 17, 2020
02:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 17, 2020
02:13 AM
Hi,
You can take a look at the CSA Specification of CCG3PA. The maximun gain is 150. With a 5 mΩ resistor, 50mA could be detected.
Regards,
Eddie
1 Reply
Mar 17, 2020
02:13 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 17, 2020
02:13 AM
Hi,
You can take a look at the CSA Specification of CCG3PA. The maximun gain is 150. With a 5 mΩ resistor, 50mA could be detected.
Regards,
Eddie