Anonymous
Not applicable
Sep 06, 2015
08:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 06, 2015
08:35 AM
Dear Community,
I'm looking for the most simple way to get started with BCM20737. Is there any ready-made F/W (or example code) I could use to achieve the following on BLE:
- Two MCUs talking to each other using a wired UART => replacing the wires with a BCM20737 (BLE Mode and UART Interface) on both sides.
- Configure/do special tasks (Pairing, control TX Power...) on the BCM20737 using AT commands or similar.
Any hints? Before I was using a HM-11 BLE module which worked in this way and was good for prototyping. But now we are looking for a more advanced and pre-certified module for the first badge of our product.
Thanks for your help!
Paul
Solved! Go to Solution.
1 Solution
Sep 06, 2015
10:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 06, 2015
10:54 AM
Thank you mwf_mmfae, David!
The ACKme looks perfect if it supports true AFH (ndutton), (see Discussion here). On a first look is not mentioned in their documentation but I will figure out.
Best,
Paul
2 Replies