- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using the Anaren WICED BLE module (A20737-based). Is it possible to use the HCI (or peripheral) UART connection directly from another CPU on the board to download firmware into the part? I'm looking for a more elegant way to provision my boards than to have to use the IDE, Anaren Programmer, or the SDK CLI tool. I'm also looking for a way to eliminate the need for a separate programming connector for the WICED module.
I've seen others ask a similar question but haven't seen any clues as to how one might do a direct download of firmware into the module.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may use the UART port of another CPU to download FW into the 20737 via its HCI UART, which is the intended usage.
I am including Anaren here to advise on their SW tools.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You may use the UART port of another CPU to download FW into the 20737 via its HCI UART, which is the intended usage.
I am including Anaren here to advise on their SW tools.