Anonymous
Not applicable
Jan 13, 2014
11:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 13, 2014
11:31 PM
I don't use any configuration register capabilitis, that is -Almost Empty Flag -Almost Full Flag -Fast CLK Bit Register In this case, doesn't need sram configuration after power-up sequence? Or it's necessary in some ways?
Solved! Go to Solution.
Labels
- Labels:
-
SYNC
1 Solution
Anonymous
Not applicable
Jan 14, 2014
11:45 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 14, 2014
11:45 PM
Hello Koike,
We understand SRAM configuration settings means the Configuration register settings.
If you are not using configuration register, then you don’t need to do configuration settings after power-up sequence. Configuration register takes the default values as mentioned in the Table 3 of the datasheet http://www.cypress.com/?docID=47172
Please let us know if you need more information on the same.
Thanks & Regards,
Sheetal
1 Reply