Dec 10, 2013
12:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 10, 2013
12:08 PM
Hi
I'm using the part CY62157EV30LL-45ZXI in 1Mx8bits mode. I understand that I understand BHE, BLE and I/O8 to I/O14 pins are not used (NC). But I also noticed that ISB2 and ICCDR specifications are valid only when /BHE and /BLE signals are tied to CMOS levels. So while operating in 1Mx8bit mode, will the ISB2 and ICCDR specifications be met?
Regards,
HiZ
Solved! Go to Solution.
Labels
1 Solution
Dec 10, 2013
12:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 10, 2013
12:10 PM
When Part is in 1M X8bit mode using BYTE# pin,BHE#, BLE#, IO0 - IO14 can be left floating.
ISB2 and ICCDR will be met in this condition for X8 Mode
1 Reply
Dec 10, 2013
12:10 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 10, 2013
12:10 PM
When Part is in 1M X8bit mode using BYTE# pin,BHE#, BLE#, IO0 - IO14 can be left floating.
ISB2 and ICCDR will be met in this condition for X8 Mode