Strictly necessary cookies are on by default and cannot be turned off. Functional, Performance and Tracking/targeting/sharing cookies can be turned on below based on your preferences (this banner will remain available for you to accept cookies). You may change your cookie settings by deleting cookies from your browser. Then this banner will appear again. You can learn more details about cookies HERE.
Strictly necessary (always on)
Functional, Performance and Tracking/targeting/sharing (default off)
Summary: The difference between Signal mode and Direct mode is: we only need to connect the EVB with the test AP created by AP, then AP will have ...
The difference between Signal mode and Direct mode is: we only need to connect the EVB with the test AP created by AP, then AP will have a menu to test TX and RX related. Its aim is to figure out if the actual running power is matching what you want, RX path has no RF de-sense in a normal running mode. If signal mode passed all the RF standard, we can have a confidence that current RF path include TX and RX, current RF configuration like NVRAM have no critical issues. We can move the product into next long-run function tests.
Which EVB is for the tests?
I choose 43340 because it has 2.4G and 5G together.
How to set 8860C before test.
1. Set the static IP address
2. configuration .
Which means creating a AP at 153 channel with 6M rate and power is -15dbm.
After AP created we use command to join the AP, then we can do the test .
Which application is needed for the tests?
I used the command console for the test because we can use a lot of embedded commands to join a specific AP and do some command input.
And we are using the normal firmware for the test, please see the command output.
test.console-BCM943340WCD1 download run
Which commands are needed before the tests?
After connection established “scan_suppress 1” , “roam_disable ” are preferred .