Attachments are accessible only for community members.
PSoC 6 BLE: Peripheral Updating Connection Parameters
Moderator
Sep 15, 2021
11:24 PM
- Subscribe to RSS Feed
- Mark as New
- Mark as Read
- Bookmark
- Subscribe
- Printer Friendly Page
- Report Inappropriate Content
Sep 15, 2021
11:24 PM
The project attached below shows how to update the Connection Parameters in a BLE connection using the PSoC 6 BLE device. Peripheral device can update the connection parameters by sending a Connection Parameter Update Request packet to the Central device. In this project, once the device connects to a peer device, a Connection Parameter Update Request can be sent from the GAP Peripheral when the user presses the switch (SW2) on the kit.
Schematic Diagram:
Hardware Required: CY8CKIT-062-BLE PSoC 6 BLE Pioneer Kit
Software Required: PSoC Creator™ 4.4, CySmart 1.3, Serial Terminal application (like TeraTerm)
PSOC Creator project and project datasheet are attached below.
Labels
Rate this article: