WICED Smart Quick Start Guide (SDK 2.x and TAG4 Board)

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
lock attach
Attachments are accessible only for community members.
MichaelF_56
Moderator
Moderator
Moderator
250 sign-ins 25 comments on blog 10 comments on blog

revisions.png

Quick Start Guide - WICED Smart™ Development System (SDK 2.X and TAG4 Board) (2 MB)

Note: Because SPI_1 (External Flash) and I2C (Bus used by sensors) share several of the same pins, you cannot boot from SPI Flash and use the sensors onboard the BCM92073X_LE_TAG4 kit (the kit will come up, but the sensors will not respond). To use the sensors, please boot from the onboard EEPROM instead.

Update: Tag 4 Quick Hardware Setup:
1. The default switch settings for USB power, booting from EEPROM are as follows:
            
A. SW6 – 2,4 ON, rest OFF
            
B. SW9 – all ON
            
C. SW8 – 1,3,5 ON, rest OFF
             
D. SW4 – VUSBs
             
E. SW5 – VREG

     
2. Additionally, during thje initial/first download, the TAG4 board requires a recovery procedure to occur:
               

A. Press-hold BOOT, press-release RESET, release BOOT             
B. Edit any make target: replace “download” with “recover UART=COMxx”

C. Use make target. Replace ‘xx’ with your COM port (found in Device Manager)
   
D. Double click make target to execute build

NOTE 1: After the initial recovery, a standard download process can be used.

NOTE 2: SW8 = 1,3,5 OFF, the remainder are ON when downloading to SFLASH


jakewtorres

0 Replies