cancel
Showing results for 
Search instead for 
Did you mean: 

Power Management

Anonymous
Not applicable

I have an Arduino setup with a temperature and humidity sensor and would like to transfer this to the Cypress Solar Powered IoT Device Kit. Which pins would I add these sensors to and how would it be programmed? Thanks.

1 Solution
Employee

Does the "Arduino setup with a temperature and humidity" mean that your would like to connect I2C sensors to Solar-Powered IoT Device?

If yes,  you can connect the sensors to pin 8 and 9 of J2.

Connector of IoT Kit.png

Regarding how to program, refer to "7.2 PSoC Creator with MiniProg3 (Program and Debug)" on the kit guide.

http://www.cypress.com/file/187321/download

Regards

Eiji

View solution in original post

2 Replies
Anonymous
Not applicable

Did you ever figure out how to get the arduino sensor setup alexander?

0 Likes
Reply
Employee

Does the "Arduino setup with a temperature and humidity" mean that your would like to connect I2C sensors to Solar-Powered IoT Device?

If yes,  you can connect the sensors to pin 8 and 9 of J2.

Connector of IoT Kit.png

Regarding how to program, refer to "7.2 PSoC Creator with MiniProg3 (Program and Debug)" on the kit guide.

http://www.cypress.com/file/187321/download

Regards

Eiji

View solution in original post

Top labels