- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have an Arduino setup with a temperature and humidity sensor and would like to transfer this to the Cypress Solar Powered IoT Device Kit. Which pins would I add these sensors to and how would it be programmed? Thanks.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does the "Arduino setup with a temperature and humidity" mean that your would like to connect I2C sensors to Solar-Powered IoT Device?
If yes, you can connect the sensors to pin 8 and 9 of J2.
Regarding how to program, refer to "7.2 PSoC Creator with MiniProg3 (Program and Debug)" on the kit guide.
http://www.cypress.com/file/187321/download
Regards
Eiji
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Did you ever figure out how to get the arduino sensor setup alexander?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Does the "Arduino setup with a temperature and humidity" mean that your would like to connect I2C sensors to Solar-Powered IoT Device?
If yes, you can connect the sensors to pin 8 and 9 of J2.
Regarding how to program, refer to "7.2 PSoC Creator with MiniProg3 (Program and Debug)" on the kit guide.
http://www.cypress.com/file/187321/download
Regards
Eiji