cancel
Showing results for 
Search instead for 
Did you mean: 

Power Management

Anonymous
Not applicable

Dear Sir,

I had the S6AE103A Evaluation Kit and would like to use it to power up an external board.

The external board requires 2.1V and I>10mA. I read the guideline and said the LDO current

can provide 10mA in normal mode. However, when i measure the evaluation kit output current,

is was just a few uA. Could i know under what condition i can get a 10mA output ?

Thanks

0 Likes
Reply
1 Solution
Moderator
Moderator
0 Likes
Reply
1 Reply
Moderator
Moderator
0 Likes
Reply
Top labels