- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am using PSOC Creator 3.3 with the CY8Ckit-050. I believe some setting or something has gotten changed but I cannot figure it out. The problem is: When I used to click the program button PSoC would program the device plugged into my computer without any further intervention. However, now when I click the button it brings up the "Select Debug Target" window and I have to press "Port Acquire" and then connect and finally the Ok button for programming to happen. This is a bit of a nuisance because I am cosntantly programming the device while I am developing my program.
Have I changed a setting somewhere? Honestly, I don't believe this to be the case as I have not been mucking around in any settings windows.
Thanks for any help.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thus,as you have set in the System Tab, Debug select as GPIO,you are encountering this phenomenon.