- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I updated my CY8CKIT-149 to Kitprog3. PSOC Programmer recognises it and I can flash it. However when I use PSOC Creator it does not connect, saying "this device was recognized but psoc creator does not support using it at this time"
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have tried with my CY8CKIT-149
KitProg3 has two modes changed by pushing the MODE (SW3) button.
1) The first one is KitProg3 CMSIS-DAP/BULK mode. In this mode the STATUS LED (LED3) turns on stably.
The KitProg3 device is shown in the Device Manager as follows.
In this mode, the device was successfully programmed.
2) The second one is KitProg3 CMSIS-DAP/HID mode. The STATUS LED (LED3) blinks in 1Hz.
In this mode, the device was successfully programmed.
On my kit, both modes can be used for program.
Regards,
Noriaki