cancel
Showing results for 
Search instead for 
Did you mean: 

PSoC Creator & Designer Software

Anonymous
Not applicable

 I just purchased the pioneer kit above and installed PSoc 3.3.  When starting a new project I do not get a window open that allows me the choice of processor or design kit as described in the application note for PSoC  designer or as described in the training video 101 #4.

0 Likes
Reply
1 Solution
Esteemed Contributor II

Welcome in the Forum!

   

Probably you are using the wrong program: You should install Creator 3.3 , not Designer (which is for PSoC1s only).

   

When starting Creator you are moved to the "Start Page". There you find near the left a scrollable area where kits and examples can be selected.

   

 

   

Bob

View solution in original post

0 Likes
Reply
3 Replies
Esteemed Contributor II

Welcome in the Forum!

   

Probably you are using the wrong program: You should install Creator 3.3 , not Designer (which is for PSoC1s only).

   

When starting Creator you are moved to the "Start Page". There you find near the left a scrollable area where kits and examples can be selected.

   

 

   

Bob

View solution in original post

0 Likes
Reply
Anonymous
Not applicable

Hi Bob

   

Thanks for you prompt response. I am using Creator 3.3, my mistake. Start page comes up fine. The choices on the left link to the Cypress web site for documentation. The create new project does not open the window I described above for selecting the kit or processor.

0 Likes
Reply
Esteemed Contributor II

The New Project dialog has changed with 3.3. I think the 101 video is a lot older than Creator 3

   

 

   

Bob