- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have been working with BLE Pioneer Kit and PRoC module.
I have a low power project that has been working for a while. I ran debug mode a few times successfully in the beginning of its development.
Then my debugging methods shifted to battery mode with my oscilloscope so many changes have been made since it was debugged over USB.
Now I get the error # mentioned in Subject, which comes up just as the first line in main loop is highlighted yellow and the debug mode disappears and error appears.
Attached is image at that point.
Any ideas?
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How are you debugging the device the message says that you have lost connection to your PSOC board. I would check the device manage for your device is is listed? Try uninstalling the device and reinstalling it in Windows.